TURBO KNOCK SENSOR PLUG KIT for RB20 RB25 RB26 RB30 (VL and SKYLINE)

This kit contains all the parts you need to add or replace the factory knock sensor wire and plug on an RB engine loom:
4 metres of signal cable
1  x  ground joiner terminal
1   x signal into ECU terminal
1  x  sensor connector terminal
1  x  sensor connector seal
1  x  sensor connector housing
 

–  Installation instructions are available here
–  Suits all RB25, RB26 and RB30 engine looms.  May suit R31 Skyline engine looms, but we are yet to confirm this.
–  Direct-replacement aftermarket parts
–  Buyer will receive parts the same as shown

*** Using an improper crimping tool will cause failed joins and void any returns ***